Lock-in detection using a cryogenic low noise looped current preamplifier for the readout of resistive bolometers

Abstract

We implemented a low noise current preamplifier for the readout of resistive bolometers. We tested the apparatus on thermometer resistances ranging from 10 Ohm to 500 Mohm. The use of current preamplifier overcomes constraints introduced by the readout time constant due to the thermometer resistance and the input capacitance. Using cold JFETs, this preamplifier board is shown to have very low noise: the Johnson noise of the source resistor (1 fA/Hz1/2) dominated in our noise measurements. We also implemented a lock-in chain using this preamplifier. Because of fast risetime, compensation of the phase shift may be unnecessary. If implemented, no tuning is necessary when the sensor impedance changes. Transients are very short, and thus low-passing or sampling of the signal is simplified. In case of spurious noise, the modulation frequency can be chosen in a much wider frequency range, without requiring a new calibration of the apparatus.

本页仅发布可检索的书目信息与作者摘要。HTML 正文、PDF 和 LaTeX 源文件是独立阅读资源，不作为搜索引擎落地内容。打开页面后会按浏览器语言自动翻译标题与摘要，并写入缓存。